[Hai-users] Easy Question

[Bruce Schroeder]

Can you connect an output to a zone input and set the output "ON" when
power is off then trigger the alarm based on that zone input (tamper zone,
etc.)

A bit convoluted and kills an output and a zone but I guess it could work.

Bruce
> I just looked at the config for my OmniPro (I believe it is the same for
> the
> OmniPro II); I didn't see any reporting codes for AC power failure.  There
> is
> a reporting code for low battery, but that is not what you are looking
> for.
>
> On Wednesday 10 December 2008 05:03 pm, you wrote:
>> Hopefully an easy question and its been a little quiet anyway,
>>
>> I usually wire up a zone on the OmniPro II for AC power by sensor relays
>> for power from a generator or the AC from the street.  And thus, the
>> Omni
>> will report open or close from that zone to the central station.   But
>> in
>> one installation, I just left the AC Power Sensor within the Omni to
>> detect
>> an AC Power Failure (no generator), thinking that it would report (call
>> out) upon an AC Power Failure.  But no call to the central station upon
>> loss of AC.  Is this a setting somewhere for calls upon AC Power Failure
>> that I am missing?  I can't get the Omni to report an AC Power Failure
>> in
>> this installation.
>
> _______________________________________________
> HAI-users mailing list
> HAI-users at tssi.com
> http://romaine.tssi.com/mailman/listinfo/hai-users
>




This transmission is intended for the use of the entity or individual to which
or whom it is addressed.  The transmission or any documents accompanying the
transmission may contain confidential information.  If you are not the intended
recipient, you are hereby notified that any disclosure, copying, distribution,
or action taken in reliance on the contents of the transmission or the
documents is strictly prohibited. If you have received this confidential
transmission in error, please destroy it and any accompanying documents and
notify the sender immediately.  Thank you.