[Hai-users] Easy Question

[Doug Ringler]

Thanks Bruce and Joe.  Yes, I can setup a zone and an output relating to 
this.  I guess I was just thinking that an AC Power Off would have been a 
reporting event for an OmniProII or at least one that one could configure in 
the setup.  But, maybe I'm just wrong on this.  Either way, I can fix but if 
I'm missing something that anyone knows, please let me know!

Thanks.

Doug Ringler
----- Original Message ----- 
From: "Bruce Schroeder" <schroeder at easternrad.com>
To: <jkv at vossen.org>
Cc: <hai-users at tssi.com>
Sent: Wednesday, December 10, 2008 6:44 PM
Subject: Re: [Hai-users] Easy Question


> Can you connect an output to a zone input and set the output "ON" when
> power is off then trigger the alarm based on that zone input (tamper zone,
> etc.)
>
> A bit convoluted and kills an output and a zone but I guess it could work.
>
> Bruce
>> I just looked at the config for my OmniPro (I believe it is the same for
>> the
>> OmniPro II); I didn't see any reporting codes for AC power failure. 
>> There
>> is
>> a reporting code for low battery, but that is not what you are looking
>> for.
>>
>> On Wednesday 10 December 2008 05:03 pm, you wrote:
>>> Hopefully an easy question and its been a little quiet anyway,
>>>
>>> I usually wire up a zone on the OmniPro II for AC power by sensor relays
>>> for power from a generator or the AC from the street.  And thus, the
>>> Omni
>>> will report open or close from that zone to the central station.   But
>>> in
>>> one installation, I just left the AC Power Sensor within the Omni to
>>> detect
>>> an AC Power Failure (no generator), thinking that it would report (call
>>> out) upon an AC Power Failure.  But no call to the central station upon
>>> loss of AC.  Is this a setting somewhere for calls upon AC Power Failure
>>> that I am missing?  I can't get the Omni to report an AC Power Failure
>>> in
>>> this installation.
>>
>> _______________________________________________
>> HAI-users mailing list
>> HAI-users at tssi.com
>> http://romaine.tssi.com/mailman/listinfo/hai-users
>>
>
>
>
>
> This transmission is intended for the use of the entity or individual to 
> which
> or whom it is addressed.  The transmission or any documents accompanying 
> the
> transmission may contain confidential information.  If you are not the 
> intended
> recipient, you are hereby notified that any disclosure, copying, 
> distribution,
> or action taken in reliance on the contents of the transmission or the
> documents is strictly prohibited. If you have received this confidential
> transmission in error, please destroy it and any accompanying documents 
> and
> notify the sender immediately.  Thank you.
>
> _______________________________________________
> HAI-users mailing list
> HAI-users at tssi.com
> http://romaine.tssi.com/mailman/listinfo/hai-users
>