[Hai-users] Easy Question

[Joseph K. Vossen]

I just looked at the config for my OmniPro (I believe it is the same for the 
OmniPro II); I didn't see any reporting codes for AC power failure.  There is 
a reporting code for low battery, but that is not what you are looking for.

On Wednesday 10 December 2008 05:03 pm, you wrote:
> Hopefully an easy question and its been a little quiet anyway,
>
> I usually wire up a zone on the OmniPro II for AC power by sensor relays
> for power from a generator or the AC from the street.  And thus, the Omni
> will report open or close from that zone to the central station.   But in
> one installation, I just left the AC Power Sensor within the Omni to detect
> an AC Power Failure (no generator), thinking that it would report (call
> out) upon an AC Power Failure.  But no call to the central station upon
> loss of AC.  Is this a setting somewhere for calls upon AC Power Failure
> that I am missing?  I can't get the Omni to report an AC Power Failure in
> this installation.