[Hai-users] RC80 thermostat

[Darren and Jody Bzdel]

I had to double check my wiring a few times before it started to work
properly. Once it was hooked up correctly the temperature cycled as
expected. Is it possible to try the sensor with a short wire near the
unit to verify the sensor is working?

I have also tried to setup my RC-80 to show in Celsius. I have changed
the setting so the panel reports in C, and when I check the status over
the phone it is also in C, but the tstat still shows F. I talked to a
HAI guru and his answer was the same - you can do it, but I am not sure
how. The manual does not say, so if anyone knows how to do it - it would
be  much appreciated.

-----Original Message-----
From: hai-users-bounces at tssi.com [mailto:hai-users-bounces at tssi.com] On
Behalf Of Tony Golden
Sent: August 1, 2006 6:27 AM
To: hai-users at tssi.com
Subject: RE: [Hai-users] RC80 thermostat

I'm sure there's a way to display Celsius, but don't remember the exact
configuration.  If you can't find it in the panel's and thermostat's
owners
manuals, check with HAI's tech support.

For the outside temperature, first verify the sensor's actually working,
by
viewing the status on the keypad.  If the temperature shows correctly on
the
keypad, then it's working/connected properly.  If it doesn't, it could
be
wired incorrectly, configured for the wrong type (Extended or not), or
the
sensor could be defective.

If the outside temperature does display correctly on the keypad, there
may
be a problem with the thermostat's communication with the panel.  See if
you
can view the thermostat's status from a keypad, and also control it.  If
you
can't do one, or both, there's a problem with the wiring, the panel's or
thermostat's configuration, or the thermostat.  It's also remotely
possible
the panel itself could be defective, but that's the least-likely
scenario --
I'd rule out all the other possibilities, first...


-----Original Message-----
From: hai-users-bounces at tssi.com [mailto:hai-users-bounces at tssi.com] On
Behalf Of Wijoyo Utomo
Sent: Tuesday, August 01, 2006 4:45 AM
To: hai-users at tssi.com
Subject: [Hai-users] RC80 thermostat

I have an RC80 and would like to know how to change the displayed
temperature into Celcius instead of Fahrenheit. Also would like to know
how to display the "OUTSIDE" temperature on the thermostat. I have set
one zone to be Outdoor Temperature and name the zone OUTDOOR, but the
thermostat does not cycle the display between the outside and current as
per instruction manual.

Thanks in advance.

Rgds,
W. Utomo


_______________________________________________
HAI-users mailing list
HAI-users at tssi.com
http://romaine.tssi.com/mailman/listinfo/hai-users