[Hai-users] ALC 4 button scene switch delays

[Tom Lyons]

Sorry for the blatantly ignorant question, but...how?

I've looked at OnQ's site and the WorthingtonSolutions
forum and knowledgebase and found nothing about how to
upgrade the firmware.  Is it a chip replacement, and
if not, how is it done?  How can I determine my
current firmware version?

Thanks for the reply, Scott.

Tom

--- "Dudoussat, Scott A."
<scott.dudoussat at homeauto.com> wrote:
> You need to update the firmware in your ALC board to
> Version 1.2 or
> later.
> 
> -Scott
>  
>  
> 
> > -----Original Message-----
> > From: hai-users-bounces at tssi.com
> [mailto:hai-users-bounces at tssi.com]
> On
> > Behalf Of Tom Lyons
> > Sent: Tuesday, March 22, 2005 9:17 AM
> > To: HAI-users at tssi.com
> > Subject: [Hai-users] ALC 4 button scene switch
> delays
> > 
> > Greetings.  This list HAS been exceedingly quiet,
> time
> > to liven it up some.
> > 
> > I have a problem with one of the ALC 4 button
> switches
> > installed in my home (connected to a 4-branch ALC
> > board on my OmniPro II).  The top two buttons of
> the
> > switches behave normally, but the bottom two have
> a
> > delay of about  30 seconds before performing their
> > programmed task.
> > 
> > It has come to the point where I am only using the
> top
> > two buttons on these switches in order to avoid
> the
> > delay.  The programmed functions perform just as
> they
> > should, only about 30 seconds after pressing the
> > button.
> > 
> > Anyone else seen this behavior before?
> > 
> > Thanks....
> > 
> > Tom
> > 
> > 
> > 
> > __________________________________
> > Do you Yahoo!?
> > Make Yahoo! your home page
> > http://www.yahoo.com/r/hs
> > 
> > _______________________________________________
> > HAI-users mailing list
> > HAI-users at tssi.com
> > http://romaine.tssi.com/mailman/listinfo/hai-users
> 
> 
> 

__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com