[Hai-users] ALC 4 button scene switch delays

[Dudoussat, Scott A.]

You need to update the firmware in your ALC board to Version 1.2 or
later.

-Scott
 
 

> -----Original Message-----
> From: hai-users-bounces at tssi.com [mailto:hai-users-bounces at tssi.com]
On
> Behalf Of Tom Lyons
> Sent: Tuesday, March 22, 2005 9:17 AM
> To: HAI-users at tssi.com
> Subject: [Hai-users] ALC 4 button scene switch delays
> 
> Greetings.  This list HAS been exceedingly quiet, time
> to liven it up some.
> 
> I have a problem with one of the ALC 4 button switches
> installed in my home (connected to a 4-branch ALC
> board on my OmniPro II).  The top two buttons of the
> switches behave normally, but the bottom two have a
> delay of about  30 seconds before performing their
> programmed task.
> 
> It has come to the point where I am only using the top
> two buttons on these switches in order to avoid the
> delay.  The programmed functions perform just as they
> should, only about 30 seconds after pressing the
> button.
> 
> Anyone else seen this behavior before?
> 
> Thanks....
> 
> Tom
> 
> 
> 
> __________________________________
> Do you Yahoo!?
> Make Yahoo! your home page
> http://www.yahoo.com/r/hs
> 
> _______________________________________________
> HAI-users mailing list
> HAI-users at tssi.com
> http://romaine.tssi.com/mailman/listinfo/hai-users