[Hai-users] question about flush mount remote temp sensor

[Joseph K. Vossen]

thanks Dan...I did notice that there is a small ridge just under the disc and after looking at the drawing that came with the sensor, it appears that the sensor needs to be installed up to the ridge with the disc slightly off of the wall, which jives with your experience.

-----Original Message-----
>From: Dan Hoehnen <dan at customautomationtech.com>
>Sent: Apr 10, 2007 8:37 AM
>To: hai-users at tssi.com
>Subject: RE: [Hai-users] question about flush mount remote temp sensor
>
>I can't answer the wire type question.  But, here is my experience with the
>1 remote temp sensor I have installed.  Initially, it was mounted flush,
>touching the wall.  This didn't seem to work very well.  Our thought was
>that it was measuring the wall temp (at least partially) and this adversely
>affected the temperature reading and/or speed of change.  I can't remember
>the exact problem now since it was several years ago.
>
>What we ended up doing was to lift the temp sensor off the wall just
>slightly.  We then painted the sensor and it still worked fine.  I'm not
>sure what wall paper would do.  You may find that you need to lift the
>sensor slightly off the wall, and then glue a piece of wall paper to it
>that's cut to its exact size.
>
>This house has a boiler for heat, with radiators in each room.  It has
>standard A/C.  
>
>Regards,
>Dan 
>
>-----Original Message-----
>From: hai-users-bounces at tssi.com [mailto:hai-users-bounces at tssi.com] On
>Behalf Of Joseph K. Vossen
>Sent: Monday, April 09, 2007 9:17 PM
>To: hai-users at tssi.com
>Subject: [Hai-users] question about flush mount remote temp sensor
>
>I'm getting ready to connect a flush mount remote temp sensor (model
>23a00-2) so that I can move my tstat to get rid of some wall clutter.  For
>this room, I would like to mount the tstat on the other side of the wall
>where it is currently, which puts the tstat in the closet; in this case, the
>wire run between the sensor and the tstat will only be about 6" or so.
>
>Do I still need to use a shielded cable in this case since the run is so
>short?  Would a piece of CAT5 work just as well and if so, do I still need
>to connect anything to the black wire (which is supposed to be the shield)?
>
>oh...and I assume you can paint over the metal disc, correct?  Is it OK to
>also wallpaper over the disc?
>
>thanks
>
>_______________________________________________
>HAI-users mailing list
>HAI-users at tssi.com
>http://romaine.tssi.com/mailman/listinfo/hai-users
>
>
>_______________________________________________
>HAI-users mailing list
>HAI-users at tssi.com
>http://romaine.tssi.com/mailman/listinfo/hai-users