[Hai-users] no controller data...

[Joseph K. Vossen]

I have an OmniPro running firmware version 1.4e; system has been installed 
for about 8 years w/o issues.  I have 2 consoles and a single expansion 
cabinet configured.  This morning, the system was armed 'away', no problem.  
When I arrived home this afternoon, both consoles were beeping and had 'no 
controller data' being displayed.  I tried to disarm the system from both 
keypads, but that didn't work.  The system 'tripped' and I had to power the 
system down, disconnect the battery in both the system and the expansion 
cabinet and disconnect the phone line.  When I powered up the system, all 
appears well.  I looked at the event logs, I see:

      system armed away
      door not ready (when I walked in)
      several motions not ready (as I walked through the house)
      burgarly
      system reset (power system off and then back on)
      all motion & glass breaks in system tripped (several msgs)
      system reset (powered system off/on due to outdoor horn :))
      disarm system

so...is this a one-time flux or is there something in the system that needs 
replaced

thanks