[Hai-users] Omni IIe and Expansion Controller

[Byron Peebles]

I am attempting a migration from Aegis 2000 to HAI Omni IIe.

I am having two problems related to:

1. All Wireless Zones (12A00-based) appear NotReady.
2. All Expansion Enclosure relay units are missing from the Units list.

For my Wireless Receiver zones, I have a combination of Wireless PIRs,
and Linear pushbotton remotes.  The PIRs need batteries, I suspect, because
they show Supervision Failure (units 11, 12 ,13) on the receiver readout.

Question:  Do I need to reprogram the Receiver to change where the zones 
are mapped?

On the Aegis 2000, the zones were 49-64, but the Omni IIe doesn't go 
that high.  My hope
was they would naturally map to zones 33-48, and it appears they have, 
but all are NOT READY.
Tests with working pushbutton units don't change the status, but I can't 
see the receiver when
I can see the computer screen, so I can't tell if one is working and the 
other isn't.  Get that?

With the Expansion Enclosure, it appears the 17-32 zones are there, but 
I don't see control units
that correspond with the relays in the enclosure.

Question: Do I need to configure anything special for the Expansion 
Enclosure Relays to be included in the Units list?

I have enabled one Expansion Module as the Expansion Enclosure.  All 
others are disabled.

Thanks!