[Hai-users] RE: Power Operated Door lock

[Dan Wright]

The current draw from the lock most likely will exceed what the Omni can
source from its on board supply.  Consider going to a double battery setup
and power the lock via a relay from the battery controlled by the HAI
output.
  -----Original Message-----
  From: hai-users-bounces at tssi.com [mailto:hai-users-bounces at tssi.com]On
Behalf Of Doug Burton
  Sent: Saturday, July 30, 2005 5:15 PM
  To: hai-users at tssi.com
  Subject: [Hai-users] RE: Power Operated Door lock




  Hiya,



  Need some help with installing (wiring) a Electric door deadbolt.



  Its 12 v fail safe lock.  The idea being when the alarm is set in way
mode, the Deadbolt energizes and locks the closet door where the System is
located, for extra protection against theft of other systems in the computer
closet.



  Best I can figure out is this should be controlled via the outputs on the
HAI board 1-8???



  But then I'm a little lost.  Would also like to power the bolt from the
HAI controller for extra reliability



  Any suggestions?



  Doug Burton



  Loan Officer

  First Financial Mortgage

  office: 310-478-0180

  cell:   323-828-3684

  fax:    310-943-2498

  email: dougburton at firstcapcorp.com


-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://romaine.tssi.com/pipermail/hai-users/attachments/20050730/5ad239bb/attachment.htm