From nolan at romaine.tssi.com Sat Nov 5 20:13:23 2016 From: nolan at romaine.tssi.com (Mike Nolan) Date: Sat, 5 Nov 2016 20:13:23 -0500 (CDT) Subject: [Hai-users] What's the current version of PC Access? Message-ID: I recently had to have the motherboard in my Aegis replaced with an Omni II Pro. The version of PC Access that I got is version 3.11.4.694 from June of 2013. Is that really the most recent version? -- Mike Nolan From mrgolden at earthlink.net Sat Nov 5 21:11:24 2016 From: mrgolden at earthlink.net (Tony Golden) Date: Sat, 5 Nov 2016 22:11:24 -0400 Subject: [Hai-users] What's the current version of PC Access? In-Reply-To: References: Message-ID: Mine was version 3.15.0.789, from 2015. However, your email prompted me to check for another update, which I downloaded this evening - 3.16.0.808. > --- Saturday, November 5, 2016 at 9:13 PM, Mike Nolan wrote: > > I recently had to have the motherboard in my Aegis replaced with an Omni > II Pro. > > The version of PC Access that I got is version 3.11.4.694 from June of > 2013. > > Is that really the most recent version? > -- > Mike Nolan From nolan at romaine.tssi.com Sat Nov 5 21:28:56 2016 From: nolan at romaine.tssi.com (Mike Nolan) Date: Sat, 5 Nov 2016 21:28:56 -0500 (CDT) Subject: [Hai-users] What's the current version of PC Access? In-Reply-To: <001901d237d3$13d50380$3b7f0a80$@earthlink.net> from "Tony Golden" at Nov 05, 2016 10:11:24 PM Message-ID: > Mine was version 3.15.0.789, from 2015. However, your email prompted me to > check for another update, which I downloaded this evening - 3.16.0.808. I tried to check for an update a couple weeks ago, but I hadn't entered the serial number correctly, I'll have to try again. I trid to insstall PC Access on another computer today but messed up somehow, and now I can't get into the program on that computer because it asks for a password and neither the default password nor the one I though I changed it to are working. Doing an unistall and re-install isn't helping, it must not fully clean out the registry on an uninstall. -- Mike Nolan From shanadog at swbell.net Sun Nov 20 08:48:04 2016 From: shanadog at swbell.net (Jack & Lynda Carnegie) Date: Sun, 20 Nov 2016 08:48:04 -0600 Subject: [Hai-users] X10 quit working Message-ID: I have an Omni IIe (the one with 3 serial ports). All my x10 has stopped working. If I connect to the controller with pc access and tell it to send a command the red light on the tw523 interface does not blink. There are two red lights on the controller board next to the Ethernet and x10 ports. The left one is constantly red, the right one is blinking. I am not sure what these lights signify. I am not sure if the tw523 went bad or the x10 output on the controller board stopped working. Can anyone help troubleshoot. Fwiw, UPB works fine. Sent from my iPad