[Hai-users] New intermittent beep upon entry

[Paul | CSI]

Are you sure you're "Unvacated Premises" is set to on
 
Regards
Paul Whyte

  _____  

From: hai-users-bounces at tssi.com [mailto:hai-users-bounces at tssi.com] On
Behalf Of Doug Ringler
Sent: January 26, 2009 5:47 PM
To: Dudoussat, Scott A.; HAI-users at tssi.com
Subject: [Hai-users] New intermittent beep upon entry


Has anyone noticed that with the new 3.0 Firmware for the OmniPro II that
upon entry when armed away and until you disarm, instead of the constant
tone there is now an intermittent tone?  Note that I mind that much....just
wondering if it was just me....don't see where this can be changed.
 
Doug Ringler

----- Original Message ----- 
From: Dudoussat, Scott A. <mailto:scott.dudoussat at homeauto.com>  
To: Allen Edwards <mailto:allen_edwards at suddenlink.net>  ;
HAI-users at tssi.com 
Sent: Monday, January 26, 2009 10:15 AM
Subject: RE: [Hai-users] Omni LT & DSL Phone


Actually what you need is a DSL splitter (a filter can be used, but the
connection must be configured like a splitter).  If you just filter the line
at the OmniLT, you will filter out DSL going to where it needs to be (i.e.
the DSL modem).  Take a look in the OmniLT manual for additional information
and wiring diagram.

 

When the OmniLT is connected to a Digital Subscriber Line (DSL), a DSL
Splitter must be used to provide separate outputs for filtered voice (phone)
and DSL (data). Splitting the voice and data is necessary because: 

 

1. The higher frequencies of the DSL signal must not pass through the OmniLT
controller. It can cause problems with the DTMF detection and the digital
dialer. 

 

2. Whenever the OmniLT is accessed on an in house telephone, the OmniLT will
disconnect the phones from the phone company lines (in this case the DSL
line). When that occurs, the DSL connection is temporarily lost. 

 

-Scott

 


  _____  


From: hai-users-bounces at tssi.com [mailto:hai-users-bounces at tssi.com] On
Behalf Of Allen Edwards
Sent: Sunday, January 25, 2009 8:58 PM
To: HAI-users at tssi.com
Subject: [Hai-users] Omni LT & DSL Phone

 

I've recently installed an Omni LT with eight wireless zones for a customer.
It works ok but, when calling the panel on an in house phone or from an
outside phone, there is a static sound for three or four seconds.  The
customer has DSL internet service and DSL filters on the two existing phones
in the house.  Would the DSL be causing the static when calling the Omni and
do I need a DSL filter here also?

 

Thank you,

Allen Edwards

 


No virus found in this outgoing message.
Checked by AVG.
Version: 7.5.552 / Virus Database: 270.10.13/1915 - Release Date: 1/25/2009
6:13 PM




  _____  




_______________________________________________
HAI-users mailing list
HAI-users at tssi.com
http://romaine.tssi.com/mailman/listinfo/hai-users


-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://romaine.tssi.com/pipermail/hai-users/attachments/20090127/4363472e/attachment.htm