[Hai-users] Remote temp sensor for (older) RC-80 tstats

[Wijoyo Utomo]

Have no experience with it, but I think it is still doable. Try to find the
termistor on the tsat board, clip it off the board and solder wire to it.
Put the termistor on the other end of the wire and hopefully it will work as
you want it to.

Rgds,
W. Utomo

> -----Original Message-----
> From: hai-users-bounces at tssi.com 
> [mailto:hai-users-bounces at tssi.com] On Behalf Of Joseph K. Vossen
> Sent: Sunday, August 24, 2008 5:33 AM
> To: hai-users at tssi.com
> Subject: [Hai-users] Remote temp sensor for (older) RC-80 tstats
> 
> 
> I'm on a jihad to eliminate wall-clutter in my home and one 
> of the things I 
> am doing is to mount my (RC-80) tstats in closets and run 
> remote temp sensors 
> back into the room.  I'm controlling the tstats via my 
> Crestron system so I'm 
> not losing any functionality.
> 
> I've notice that some of the tstats, which are going on 10 
> years old now, do 
> not have the 3 holes in the circuit board (location J4) to mount the 
> connector for the sensor.
> 
> Is there another point on the circuit board that I can tie 
> into or am I going 
> to have to replace these tstats just to get a connection point?
> 
> thanks
> 
> _______________________________________________
> HAI-users mailing list
> HAI-users at tssi.com http://romaine.tssi.com/mailman/listinfo/hai-users
> 
> 
> -- 
> No virus found in this incoming message.
> Checked by AVG. 
> Version: 7.5.526 / Virus Database: 270.6.7/1628 - Release 
> Date: 8/22/2008 6:32 PM
> 
>