From jkv at vossen.org  Sat Aug 23 17:33:05 2008
From: jkv at vossen.org (Joseph K. Vossen)
Date: Sat Aug 23 17:32:10 2008
Subject: [Hai-users] Remote temp sensor for (older) RC-80 tstats
Message-ID: <E1KX1eW-00038X-00@pop06.mail.atl.earthlink.net>

I'm on a jihad to eliminate wall-clutter in my home and one of the things I 
am doing is to mount my (RC-80) tstats in closets and run remote temp sensors 
back into the room.  I'm controlling the tstats via my Crestron system so I'm 
not losing any functionality.

I've notice that some of the tstats, which are going on 10 years old now, do 
not have the 3 holes in the circuit board (location J4) to mount the 
connector for the sensor.

Is there another point on the circuit board that I can tie into or am I going 
to have to replace these tstats just to get a connection point?

thanks

From utomow at telkom.net  Sat Aug 23 21:33:58 2008
From: utomow at telkom.net (Wijoyo Utomo)
Date: Sat Aug 23 21:34:06 2008
Subject: [Hai-users] Remote temp sensor for (older) RC-80 tstats
In-Reply-To: <E1KX1eW-00038X-00@pop06.mail.atl.earthlink.net>
Message-ID: <000201c90591$dcf46210$0300a8c0@WIJOYO>

Have no experience with it, but I think it is still doable. Try to find the
termistor on the tsat board, clip it off the board and solder wire to it.
Put the termistor on the other end of the wire and hopefully it will work as
you want it to.

Rgds,
W. Utomo

> -----Original Message-----
> From: hai-users-bounces@tssi.com 
> [mailto:hai-users-bounces@tssi.com] On Behalf Of Joseph K. Vossen
> Sent: Sunday, August 24, 2008 5:33 AM
> To: hai-users@tssi.com
> Subject: [Hai-users] Remote temp sensor for (older) RC-80 tstats
> 
> 
> I'm on a jihad to eliminate wall-clutter in my home and one 
> of the things I 
> am doing is to mount my (RC-80) tstats in closets and run 
> remote temp sensors 
> back into the room.  I'm controlling the tstats via my 
> Crestron system so I'm 
> not losing any functionality.
> 
> I've notice that some of the tstats, which are going on 10 
> years old now, do 
> not have the 3 holes in the circuit board (location J4) to mount the 
> connector for the sensor.
> 
> Is there another point on the circuit board that I can tie 
> into or am I going 
> to have to replace these tstats just to get a connection point?
> 
> thanks
> 
> _______________________________________________
> HAI-users mailing list
> HAI-users@tssi.com http://romaine.tssi.com/mailman/listinfo/hai-users
> 
> 
> -- 
> No virus found in this incoming message.
> Checked by AVG. 
> Version: 7.5.526 / Virus Database: 270.6.7/1628 - Release 
> Date: 8/22/2008 6:32 PM
> 
> 


