[Hai-users] Somfy blind control - ignore last post

[Dan Hoehnen]

Sorry about the duplication.  This one must have been from my original post
that was held since I sent it with a non-subscribed email address.

Dan

-----Original Message-----
From: hai-users-bounces at tssi.com [mailto:hai-users-bounces at tssi.com] On
Behalf Of Dan Hoehnen
Sent: Saturday, March 26, 2005 6:51 PM
To: hai-users at tssi.com
Subject: [Hai-users] Somfy blind control

I'd like to use an Omni Pro II in an upcoming project that uses Somfy blind
motors.  The Somfy blind interface requires contact closures that last less
than 0.5 seconds.  The Somfy web site even has a technical document showing
the connection between a Somfy DC5 blind controller and an Omni.  It also
states a contact closure time of 400ms is needed to perform the UP and DOWN
functions.  

How do I get OP2 outputs to turn on for only 0.4 seconds?  I thought the
Omni outputs had a resolution of 1 second.  

Regards,
Dan Hoehnen
Custom Automation Technologies, Inc.
http://www.customautomationtech.com
614-939-iCAT (4228)



_______________________________________________
HAI-users mailing list
HAI-users at tssi.com
http://romaine.tssi.com/mailman/listinfo/hai-users