[Hai-users] Somfy blind control

[Andrew Ward]

I have the Somfys.

the 1 sec value works fine with the HAT. It is what I use.

400 ms is probably a minimum... 

It works well and I've had no problems. The somfys are very nice.


-Andrew

--------------------------------------------------------------------------
      ..         ..       | Andrew Ward      | Office: 800.800.1180 x72773
      ||         ||       | Routing          | Direct: 408.527.2773  
      ||         ||       | Technology Group | 
     ||||       ||||      | CCMSBU           | 
 ..:||||||:...:||||||:..  | * Diagnostics *  | pers URL http://a.ward.name
 C i s c o S y s t e m s  | * Development *  | Email : award at cisco.com
--------------------------------------------------------------------------
group URL: http://wwwin-eng.cisco.com/Eng/Core/WWW/GSR/gsr_diags.html


On Sat, Mar 26, 2005 at 10:23:21PM -0500, Dan Hoehnen wrote:
> I'd like to use an Omni Pro II in an upcoming project that uses Somfy blind
> motors.  The Somfy blind interface requires contact closures that last less
> than 0.5 seconds.  The Somfy web site even has a technical document showing
> the connection between a Somfy DC5 blind controller and an Omni.  It also
> states a contact closure time of 400ms is needed to perform the UP and DOWN
> functions.  
> 
> How do I get OP2 outputs to turn on for only 0.4 seconds?  I thought the
> Omni outputs had a resolution of 1 second.  
> 
> Regards,
> Dan Hoehnen
> Custom Automation Technologies, Inc.
> http://www.customautomationtech.com
> 614-939-iCAT (4228)
> 
> 
> 
> _______________________________________________
> HAI-users mailing list
> HAI-users at tssi.com
> http://romaine.tssi.com/mailman/listinfo/hai-users